Most of the information in the above sections explains how to install a pop rivet using a pop rivet gun since they are most common. Also, the side of the rivet that deforms expands into three petals, which increases the surface area and prevents the rivet body from pulling through the plastic. Finally, special rivets for plastic riveting are available. However, if that side of the joining is inaccessible, glue on washers in advance. One solution is to use washers on the side of the fastened material that has the deformed rivet. During operation, the rivet gun will likely pull the rivet body through the plastic before the mandrel breaks off. ![]() The metal riveting process does not work with plastic because plastic is too soft to hold typical rivets. Second, to avoid splitting, use a high-speed carbide drill to pre-drill the holes the rivets will go through. First, riveting does not work with soft woods like cedar and pine: the rivets will split the wood. There are two important differences to understand, though. The riveting process with wood is similar in many ways to the metal process. It is typical to operate the trigger mechanism multiple times to break off the mandrel.Operate the rivet’s trigger mechanism until the mandrel breaks off.Insert the rivet’s body into the pre-drilled hole.Insert the rivet’s mandrel into the rivet gun’s nose piece.This ensures that the connection will hold when the rivet’s body expands. Use a drill bit that is slightly smaller than the rivet’s diameter.Drill holes that go through both pieces of metal at each rivet installation point.Align the two pieces in the position they should maintain after riveting.The following steps explain how to fasten two pieces of metal together with rivets. Riveting is also applicable with wood and plastic. The most common use for a rivet gun is to fasten two separate pieces of metal together. Ready to operate without compressed air or electricityĪdjust to control the power impacting the rivet Manual, electric, and pneumatic rivet guns have the following advantages and disadvantages. A later section will discuss other rivet types. Note: The above information discusses pop riveting since pop rivets are the most common. The user holds the front handle in one hand and pushes the back handle towards the front handle to operate the tool. ![]() A manual rivet gun's trigger mechanism is the gun's two handles. A finger can pull the trigger on a pneumatic and electric rivet gun.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |